Thought I would install the FTDI USB - Serial converter driver. Voila, this gave me a com port and it was happy WOOHOO! I changed the flow to hardware and launched SB and made sure that the com ports matched. Then I thought, ok I will tell it what it is. Now when I plug it in it comes back with unknown device. Then I found a thread that said that I would need a USB/Serial converter so I went out and bought one. Also, the ftdunin (which is supposed to be an uninstaller for the ftdi driver if you still have it and it is not in the add/remove is an empty zip folder)!įor the inf and Roland when I point to it, it says that the driver is not compatible with this version of windows. So far I have gone through cdm20600, cdm20814_setup, Roland RWD-029, mh-cutter driver and the USCutter inf on the small cd. ![]() I uninstalled each driver before trying the other. My device manager does show a USCUTTER under unknown device but it is not functioning and there are no com ports. It says installing driver and then comes back with not installed. ![]() First I tried to download the 7 driver, reboot and plug in USB. I purchased the MH-721 and I run Win 7 64bit. ![]() So I am hoping that someone else can assist me. Ok, so i emailed support and have not heard anything from them.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |